The first action to take is to shut the normal water to your drain or bath. In situation it is the drain leaking, you will discover below within the mirror a several of buttons on the walls, near them all the way and start the taps to make sure the normal water has been shut. In situation it is the bath, it will be necessary to shut the normal water to the entire house; you will discover water device outside the home or in the underground room. Again near it and start a several of taps within so water pipe joints are absolutely purged.
These guidelines apply to a leaky bath and to a water drain. Using the correct screw driver, eliminate the manages with the characters H and C from water valves. These should be nasty or steel, pry them carefully and they will come off. Below them you will see attach leads, get them and take the buttons out. Taking them out may take a little effort because they have been there for a while but with a little balancing they will come out. You will see a long cyndrical tube which at the end, closest to the walls, will have the shape of a big nut.
Take the wrench and put it firmly over the nut and turn it strongly counterclockwise. Everything will move, keep switching until you eliminate it from the walls. When eliminating it be cautious not to damage or reduce a nasty band which provides a gasket to keep water from leaking along the sides of the tap. Inside the device you will see a little rubberized stopper, usually black, that ends the discharge when water is off. These corks wear down, rip, or become misshaped with time; this is what causes the circulation.
Unscrew the stopper and head out to the shop to get a new one. These come in little containers which contain several corks and nails. The kit may also contain various dimensions of corks so be cautious when choosing the ones you will be buying. Once at home all you have to do is opposite the process. Find the right size stopper, it should fit comfortable within the valves platform. If it is too big, it will not near the discharge effectively and if it is very little water will continue to circulation. This is why you have to take the stopper with you to the shop. You have to buy one that has exactly the same area as the old one.
It is advisable to change both corks simultaneously, if one is leaking the other one will probably start leaking soon. You have already cut the normal water so why not get the job absolutely done and forget about a leaky bath for a few years. Screw the corks set up strongly, not too limited to deform it and not to reduce so that it goes. Put the valves back again switching it clockwise until it is limited against the walls. Reassemble the manages and you are done. In a few minutes, held on money, and best of all you have become a plumbing technician.